|
[Sponsors] |
November 3, 2016, 07:03 |
Wall Boundary with Mass Source
|
#1 |
New Member
Join Date: Apr 2016
Posts: 7
Rep Power: 9 |
Hello all together!
Till now i was working in CFX. For my specific case i used a Wall-Boundary with a mass-source through the continuity equation and that worked pretty well. Now i would like in Fluent to do exactly the same. I know there are the DEFINE_SOURCE und DEFINE_UDS_FLUX UDFS. Need an Advice wich should i better use. Thank you! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |