Adding points to read results

Mateusz93 · December 4, 2016, 18:30

Hi!

I want receive velocitygraphs in some points.
I have 26 simulations and I have to read parameters in 80 points.
How I can write coordinates of these points in Ansys Fluent using console?

I was looking for in Help, but I haven't received the answer.
Please, this is very important for my University.

Thanks in advance!
Greetings,
Mat

kirmaks · December 5, 2016, 07:05

Hallo,

You can try to make it in CFD-Post, You can create a post-processing template there and read every file separately or You can use it in a batch mode with a script.

Best regards, Maks

Mateusz93 · December 5, 2016, 08:01

I need ASCII, Location: Cell Center and Delimiter: Space, and:
-Velocity Magnitiude, Velocity: X, Y, Z
-all pressures (Static, Dynamic etc)
-all subxxx options
-Q crit and normalized
-Wall Yplus
-all of options with kinetic energy if is it available
Everyting in every of my 75 points.
Probably I can't receive these results in CFD Post.

Could You tell me how I can write this script? Is it hard?

Big thanks for Your answer!

December 4, 2016, 18:30	Adding points to read results	#1
Mateusz93 New Member Mateusz Join Date: Dec 2016 Posts: 2 Rep Power: 0	Hi! I want receive velocitygraphs in some points. I have 26 simulations and I have to read parameters in 80 points. How I can write coordinates of these points in Ansys Fluent using console? I was looking for in Help, but I haven't received the answer. Please, this is very important for my University. Thanks in advance! Greetings, Mat

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How I can introduce my power heat (W) in chtMultiRegionFoam?	aminem	OpenFOAM Pre-Processing	32	August 29, 2019 02:23
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 10:52
[OpenFOAM] How to compress results files so that paraview can still read them	mirko	ParaView	2	January 20, 2011 11:07
adding a shell for sensor points	Kian	Siemens	3	August 22, 2007 11:06
Code to read in results on a BlockMeshcreated mesh as structured arrays	brooksmoses	OpenFOAM Post-Processing	0	December 5, 2005 19:57

December 5, 2016, 07:05		#2
kirmaks Member KirMaks Join Date: Aug 2016 Posts: 34 Rep Power: 9	Hallo, You can try to make it in CFD-Post, You can create a post-processing template there and read every file separately or You can use it in a batch mode with a script. Best regards, Maks

December 5, 2016, 08:01		#3
Mateusz93 New Member Mateusz Join Date: Dec 2016 Posts: 2 Rep Power: 0	I need ASCII, Location: Cell Center and Delimiter: Space, and: -Velocity Magnitiude, Velocity: X, Y, Z -all pressures (Static, Dynamic etc) -all subxxx options -Q crit and normalized -Wall Yplus -all of options with kinetic energy if is it available Everyting in every of my 75 points. Probably I can't receive these results in CFD Post. Could You tell me how I can write this script? Is it hard? Big thanks for Your answer!