|
[Sponsors] |
October 2, 2018, 17:28 |
pressure outlet on side faces
|
#1 |
New Member
Join Date: Oct 2018
Posts: 1
Rep Power: 0 |
Hi everyone,
I would like to simulate air and CO2 in a cube. B.C. for front face is velocity inlet and for rear face is pressure outlet. CO2 should leave the cube, but the problem is CO2 reach side walls and go with air flow and leave the cube. If I set B.C. to pressure outlet for side faces, reversed flow will appear and solution does not converge. Is there any way to set pressure outlet B.C. for side faces without reversed flow? Or any solution that just CO2 pass through the side faces and air flow goes on? Thanks for any help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 10:58 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |