 |
 |
 |
|
|
|
[Sponsors] | ||||
March 9, 2017, 06:22
|
Centrifugal Compressor Design Validation
|
#1 |
|
New Member
Mert
Join Date: Sep 2016
Posts: 10
Rep Power: 9  |
Dear All,
I am simulating a turbocharger's compressor in steady state with mass flow inlet and pressure outlet conditions (i have these boundary values from experiments) winth constant rpm. I have validated the results of the model. Now, I have changed the blade geometry and i want to simulate new design. I want to measure forces acting on blade surfaces of both designs and compare them. (I will use same rpm's for both cases. I also want to measure pressure ration of new design) However, I do not know where to start from the new simulation. Cause I dont have measurement results for boundaries. Could you please help me for boundary conditions? |
|
|
|
|
|
March 12, 2017, 09:57
|
|
#2 |
|
New Member
Mert
Join Date: Sep 2016
Posts: 10
Rep Power: 9 |
anybody to help?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Autoblade centrifugal pump template | mahdi balali | Fidelity CFD | 3 | February 18, 2014 08:56 |
| Centrifugal Pump CAD Model Required for validation | bhatiadinesh | CFX | 1 | June 25, 2013 04:16 |
| CFX problem in ubuntu (linux) | Vigneshramaero | CFX | 0 | July 13, 2012 10:22 |
| SIG Turbo ERCOFTAC Centrifugal Pump - OF Revision Problem? | marcelgt87 | OpenFOAM | 18 | June 26, 2012 08:59 |
| CFX-Pre problem, pls help!!! | cth_yao | CFX | 0 | February 17, 2012 00:52 |
Linear Mode
