 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2017, 23:30
|
pemfc with porous layer
|
#1 |
|
New Member
Ali
Join Date: Apr 2017
Posts: 2
Rep Power: 0  |
Hi guys
I have a simulation as water management in the fuel cell membrane proton porous layer One such model to do it? Two-phase flow by vof thanks a lot |
|
|
|
|
|
May 26, 2017, 00:06
|
|
#2 | |
|
Senior Member
Ramakant Gadhewal
Join Date: Apr 2010
Location: Chemical Engineering,National Institute of Technology,Warangal (T.S.),India
Posts: 130
Rep Power: 16 |
Quote:
are you writing any code for PEM fuel cell? |
||
|
|
|
||
|
May 28, 2017, 00:09
|
|
#3 | |
|
New Member
Ali
Join Date: Apr 2017
Posts: 2
Rep Power: 0 |
Quote:
i don't know how writhing UDF ' this is my case must be modeling in ANSYS Fluent http://www.sciencedirect.com/science...78775310016988 i need to writing udf for porous layer in 1 and 0.3 thanks |
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| y+ = 1 boundary layer mesh with snappyHexMesh | Arzed23 | OpenFOAM Running, Solving & CFD | 6 | November 23, 2022 15:15 |
| [snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
| Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |
Linear Mode
