|
[Sponsors] |
June 25, 2017, 04:45 |
3D Parabolic flow doubt
|
#1 |
New Member
Nishanth
Join Date: Jun 2017
Posts: 3
Rep Power: 8 |
Hi everyone,
I simulated a 3D parabolic flow through arteries and wrote udf for inlet boundary condition. I went on to validate the results and I found some discrepancies in my maximum facet value comparison. Can anyone give me an idea as to where I am going wrong? The red curve indicates result from my simulation and the blue one shows the actual result. Why is my velocity value not going negative? Kindly reply asap. Thank you guys |
|
June 26, 2017, 13:47 |
|
#2 |
New Member
Nishanth
Join Date: Jun 2017
Posts: 3
Rep Power: 8 |
Guys? does anyone know why? Pls respond. It would be really helpful to me.
Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pipe flow simulation problem with pisoFoam: not getting parabolic profile | sahmed | OpenFOAM Running, Solving & CFD | 1 | September 7, 2016 14:00 |
Flow Between Parallel Plates With Parabolic Entrance Velocity | saaghi | Main CFD Forum | 8 | February 7, 2014 08:06 |
Gate valve flow simulations... | nikesh | FloEFD, FloWorks & FloTHERM | 5 | January 28, 2014 01:31 |
Flow meter Design | CD adapco Group Marketing | Siemens | 3 | June 21, 2011 08:33 |
simpleFoam Blows up with Parabolic Inlet Pipe Flow | swahono | OpenFOAM | 0 | December 6, 2010 19:37 |