Home > Forums > Software User Forums > ANSYS > FLUENT

How to modify injection/droplet temperature through journal or similar

Mark Forums Read

Reply

Search this Thread

September 22, 2017, 04:28	How to modify injection/droplet temperature through journal or similar	#1
2phase New Member Martin Join Date: Apr 2017 Location: Germany Posts: 26 Rep Power: 10	Hi everyone, I am wondering if there is any solution to the following problem: - I do multiphase calculations with water droplets in air to calculate evaporation and condensation rates - I need to do quite a lot of simulations with different droplet temperature By now I did not find a way to change the injection temperature via journal files or something similar, so that I wouldn't have to modify every single case but just change a value in a text file or something. Any suggestions are appreciated. Cheers Martin

Reply

Tags

dpm, injection, journal file, temperature

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Static temperature and Total temperature	Jong-Yoon	FLUENT	0	September 25, 2016 02:42
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 07:27
Inlet won't apply UDF and has temperature at 0K!	tccruise	Fluent UDF and Scheme Programming	2	September 14, 2012 07:08
monitoring point of total temperature	rogbrito	FLUENT	0	June 21, 2009 18:31
Problems With Journal When Writing Forces To File	Andrew	FLUENT	2	September 23, 2005 03:12

All times are GMT -4. The time now is 22:50.