 |
 |
 |
|
|
|
[Sponsors] | ||||
Non-conformal mesh autimatically created walls - do these act as solid walls? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 17, 2017, 07:28
|
Non-conformal mesh autimatically created walls - do these act as solid walls?
|
#1 |
|
Member
Vestdam
Join Date: Nov 2017
Posts: 41
Rep Power: 7  |
Hi there
I have created a non-conformal hexahedral mesh on the extracted fluid domain of a centrifugal fan and when importing the mesh in Fluent, interfaces are created. This is all fine, but I am wondering, when the interfaces are automatically made, additional walls are created when the mesh is not in contact (for example on each side of an impeller blade). Do these walls act as a solid wall, so that I can make it rotating? When I display the automatically created walls, nothing is displayed. Capture.jpg Thank you in advance. |
|
|
|
|
|
November 21, 2017, 08:07
|
|
#2 |
|
New Member
Gudjon Thor Olafsson
Join Date: Nov 2017
Posts: 1
Rep Power: 0 |
I was wondering the same about these walls
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [snappyHexMesh] Unwanted mesh created by snappyHexMesh--baffle | bieshuxuhe | OpenFOAM Meshing & Mesh Conversion | 2 | April 23, 2014 01:59 |
| Developing Multi-Region Conformal Mesh | pkirchner | STAR-CCM+ | 7 | February 2, 2012 15:33 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Linear Mode
