|
[Sponsors] |
Problem with a moving wall and multiphase model |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 28, 2017, 20:09 |
Problem with a moving wall and multiphase model
|
#1 |
New Member
imane EL JIRARI
Join Date: Dec 2017
Posts: 7
Rep Power: 8 |
Hello ,
I have a problem with Fluent : I am working on a project that aims to model a ballistic impact of a bullet on a shear thickening fluid , but on Fluent , It shows juste one phase ( instead of two phases constitued by air and the shear thickening fluid , using VOF) and the bullet doesn't move even if i used a compiled UDf in order to generate a dynamic mesh ? Could anyone help me ? I can save you the entire model Thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
Multiphase simulation of bubble rising | Niru | CFX | 5 | November 25, 2014 13:57 |
Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 14:32 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |