 |
 |
 |
|
|
|
[Sponsors] | ||||
when velocity (Reynolds number) increases ...... |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 10, 2018, 15:29
|
when velocity (Reynolds number) increases ......
|
#1 |
|
New Member
waqar hazoor
Join Date: Oct 2017
Posts: 24
Rep Power: 5  |
hi all.
i am facing problem in my simulation work. in fluent when i put small values around 30 to 50 m/s for flow the solution work well and converged. but for higher values above 50 to 80 it gives me " Divergence detected in AMG for temperature : protective actions enabled! "Divergence detected in AMG for Temperature, temporarily solve with BCGSTAB! other setup is same for each case only i chance velocity and this happened. can anyone please explain me , the case is jet impingement heat transfer Regards. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 14:06 |
| AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 05:13 |
| [General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 19 | June 11, 2020 16:54 |
| [snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 10 | August 5, 2019 20:18 |
| Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 16:03 |
Linear Mode
