Extrude mesh from boundary face

acalado · March 12, 2018, 16:16

Hi gents,

I'd like to extrude the mesh beyond a boundary face for a certain distance. I have done this in the past with STAR-CCM+ and was wondering if something similar exists for Fluent.

My guess is yes, and searching around in the guide it says you can go to

mesh → modify-zones → extrude-face-zone-delta

Except when I click over the Mesh tab I do not get these options.

Any ideas?
Thanks in advance!

LuckyTran · March 12, 2018, 17:59

Don't use your mouse. Type them into the Text-User-Interface (TUI)

acalado · March 12, 2018, 18:08

I found that if I use serial mode and use the text command I can build the mesh.

However I got an error saying the mesh was not connected (face missing). Trying to run it gives the AMG solver issue, but it's most certainly due to the new mesh being disconnected.
I tried mesh repair but was not successful.

Is this normal? Did I miss something?

March 12, 2018, 16:16	Extrude mesh from boundary face	#1
acalado Senior Member André Join Date: Mar 2016 Posts: 133 Rep Power: 11	Hi gents, I'd like to extrude the mesh beyond a boundary face for a certain distance. I have done this in the past with STAR-CCM+ and was wondering if something similar exists for Fluent. My guess is yes, and searching around in the guide it says you can go to mesh → modify-zones → extrude-face-zone-delta Except when I click over the Mesh tab I do not get these options. Any ideas? Thanks in advance! __________________ Sapere aude!

March 12, 2018, 18:08		#3
acalado Senior Member André Join Date: Mar 2016 Posts: 133 Rep Power: 11	I found that if I use serial mode and use the text command I can build the mesh. However I got an error saying the mesh was not connected (face missing). Trying to run it gives the AMG solver issue, but it's most certainly due to the new mesh being disconnected. I tried mesh repair but was not successful. Is this normal? Did I miss something? __________________ Sapere aude! Last edited by acalado; March 13, 2018 at 09:25.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 06:38
Radiation in semi-transparent media with surface-to-surface model?	mpeppels	CFX	11	August 22, 2019 08:30
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 19:57
Wrong flow in ratating domain problem	Sanyo	CFX	17	August 15, 2015 07:20
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11

March 12, 2018, 17:59		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,845 Rep Power: 68	Don't use your mouse. Type them into the Text-User-Interface (TUI)