 |
 |
 |
|
|
|
[Sponsors] | ||||
May 29, 2018, 06:04
|
adding electrical setups to fluent
|
#1 |
|
New Member
tar
Join Date: May 2018
Location: iran
Posts: 2
Rep Power: 0  |
in my project I need to have an electrical section to add some features to my project. then after fluent module I want to send data to en electrical one. but I do not know that how is it possible.
I work on micro droplets and I want to move it by some electrodes (by applying voltage to them). the schematic of the project is attached here. Capture.jpg |
|
|
|
|
 |
| Tags |
| digital micro fluidic |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| chtMultiRegionSimpleFoam: crash on parallel run | student666 | OpenFOAM Running, Solving & CFD | 3 | April 20, 2017 12:05 |
| conjugateHeatFoam + interFoam | farhagim | OpenFOAM Programming & Development | 15 | July 19, 2016 08:55 |
| Adding Texture in Fluent | alex_gtz | FLUENT | 0 | July 18, 2016 05:21 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 23:56 |
| Electrical conductivity of water in FLUENT | ppcf | FLUENT | 0 | August 29, 2011 21:30 |
Linear Mode
