 |
 |
 |
|
|
|
[Sponsors] | ||||
Unassigned interface zone detected for interface 38............ |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 22, 2018, 22:11
|
Unassigned interface zone detected for interface 38............
|
#1 |
|
New Member
Ayodele Adeyemi
Join Date: May 2018
Posts: 4
Rep Power: 8  |
Dear Friends,
Can someone help me please. I get below response from FLUENT 16.1 when I check mesh created in ICEM: "Checking mesh........................ WARNING: Unassigned interface zone detected for interface 38............ Done. WARNING: Mesh check failed". I am simulating internal flow through a duct, made up of different sections that are bolted together. Thanks in advance for your guidance. |
|
|
|
|
|
| Tags |
| check, error, fluent 16.1, mesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
| [Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 01:47 |
| polyhedral cells | destroy | FLUENT | 0 | January 18, 2018 05:14 |
| unassigned interface zone warning in FLUENT | hapsari devi | FLUENT | 26 | December 11, 2017 06:28 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
