|
[Sponsors] |
IN dpm model,how to set the Number of continuous phase Iterations per dpm? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 1, 2018, 00:42 |
IN dpm model,how to set the Number of continuous phase Iterations per dpm?
|
#1 |
New Member
mikewong
Join Date: Apr 2018
Posts: 11
Rep Power: 8 |
Both continuous and particl phase is steady 。how to set this number (frequency),the default number is 20.
I first get the convergeged results without dpm injection,and then enable the dpm model。 should i make a enough number to allow each continuous phase iterations is convereged after injection? Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
chtMultiRegionSimpleFoam turbulent case | Aditya Patil | OpenFOAM Running, Solving & CFD | 6 | April 24, 2017 22:13 |
HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
[OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library | aylalisa | OpenFOAM Installation | 23 | June 15, 2015 14:49 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |