Define interfaces in TurboGrid's mesh

alsawy · September 15, 2018, 05:38

Hi.
I made a blade mesh in Turbogrid and then directly linked it to fluent.
It has 3 cell zones, Inlet, blade passage and outlet.
It works fine but there's a problem in the domain interfaces ( i.e. interface between inlet & blade passage.. and interface between blade passage & outlet)

It's one-sided face. not two-sided to create an interface. and even this one-sided face can only be an interior or a wall. (Screenshot is attached)

it's a transient simulation, so I think defining a mixing plane will not work either.

so how can i define these interfaces?

LuckyTran · September 15, 2018, 08:51

How many cell zones do you have? You probably have only 1.

alsawy · September 15, 2018, 12:42

Quote:

Originally Posted by LuckyTran

How many cell zones do you have? You probably have only 1.

nope. 3 cell zones
inlet, passage and outlet

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface	Kryo	OpenFOAM Meshing & Mesh Conversion	13	February 17, 2022 07:34
Laminar Kinetic Energy Model (Walters 2008)	logoswort	Fluent UDF and Scheme Programming	2	May 19, 2017 19:41
An odd ERROR	mdakbari	Fluent UDF and Scheme Programming	7	April 4, 2016 04:30
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 09:38

September 15, 2018, 08:51		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,676 Rep Power: 66	How many cell zones do you have? You probably have only 1.