[gartz89]

Hello folks. At introduction of my problem is, I've got a transient flow. I've done my simulation as well. In the solver of transient flow, I've got a little time size (0.5s) and a lot of number time steps (200). So I need data like a temperature, pressure and etc for every number of time steps in CFD post results, but when I go to timestep selector and click to every time steps for each parametur, it cost my time and my patience. So the main question is. Is there have some option in CFD-post to get all of my time steps results in a table or something else, because It's really difficult to write every single parameter for each number of time steps. I would like to thanks, if someone give advice or something. Thanks and regards !

[piprus]

Hi,

I'm not sure if it helps since I've never tried your way, instead I would create monitors for specific parameters back in Fluent and then re-run the simulation.

Regards,
Piotr

[gartz89]

I solved my problem. When I created function for the time and for each parameter, was easy to export my function in excel and all of my data now are in tables . Thanks and regards!