meshing one fluid into two parts

Andriy70 · August 1, 2019, 04:14

I was wondering what will happen if i seperate a fluid domain into two parts and make a non-conformal mesh? (the fluid is water in all parts). the reason that i'm doing it is that i want to create finer mesh for a part and as a result reduce the number of mesh.
in this case, Will the results be the same as when i use just one part?
I wanna do this in fluent, that's why i asked this question in fluent forum.

davex1234 · August 1, 2019, 10:58

Use 2 fluid blocks and apply a local mesh to the one that you want to have finer cells.

August 1, 2019, 04:14	meshing one fluid into two parts	#1
Andriy70 New Member Hossein Join Date: Sep 2015 Location: Iran Posts: 2 Rep Power: 0	I was wondering what will happen if i seperate a fluid domain into two parts and make a non-conformal mesh? (the fluid is water in all parts). the reason that i'm doing it is that i want to create finer mesh for a part and as a result reduce the number of mesh. in this case, Will the results be the same as when i use just one part? I wanna do this in fluent, that's why i asked this question in fluent forum.

August 1, 2019, 10:58		#2
davex1234 New Member Join Date: Jul 2019 Posts: 3 Rep Power: 6	Use 2 fluid blocks and apply a local mesh to the one that you want to have finer cells. Andriy70 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Parts Based Meshing	skapetan	STAR-CCM+	10	January 12, 2022 14:55
[ICEM] Meshing of fluid and solid zone of complex structure through OCTREE	Nils_H	ANSYS Meshing & Geometry	8	February 21, 2020 16:34
Question about adaptive timestepping	Guille1811	CFX	25	November 12, 2017 17:38
[ANSYS Meshing] Meshing separate parts	Mana	ANSYS Meshing & Geometry	0	May 6, 2014 03:06
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11