|
[Sponsors] |
March 29, 2019, 05:47 |
Zone not processed when separating the cell
|
#1 |
Member
Saurabh Das
Join Date: Jul 2018
Posts: 43
Rep Power: 7 |
I am trying to separate a domain into two zones.
For doing that, I marked the points that define the boundary. Now that these points were in a register, I clicked on separate->cell, click on the adapt option, chose the cell and the register,and click on 'separate'. However an error message is shown. 'Zone not processed.' Could anyone please tell me what is it that's missing? What am I doing wrong? What's the right approach? Thank you. |
|
Tags |
fluent, separate cell zones |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about common cell zone interaction | Maralady | FLUENT | 0 | June 17, 2013 23:31 |
About Cell Zone Conditions | Liufeng_ustb | FLUENT | 0 | May 17, 2013 23:28 |
Segmentation Fault in fluent3DMeshToFoam | cwang5 | OpenFOAM Bugs | 23 | April 13, 2011 15:37 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |