|
[Sponsors] |
May 20, 2019, 04:37 |
multiphase Flow
|
#1 |
New Member
Ali
Join Date: May 2019
Posts: 11
Rep Power: 7 |
Hi,Everyone hope all of you are good in health and doing well. I am using fluent
to heat transfer between two circular tube.after the completion of simulation when i see temperature contour there is nothing happen in inner tube but the heat is transfer occurred in mid wall.Mid wall is between outer and inner tube. I also check animation where fluid is flowing in both tube. Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
About Some Concepts:Laminar flow, turbulent flow, steady flow and time-dependent flow | Jing | Main CFD Forum | 8 | October 5, 2018 17:02 |
multiphase flow ,mass and volume fraction imbalance | sope111 | CFX | 16 | September 3, 2018 00:10 |
Review: Reversed flow | CRT | FLUENT | 1 | May 7, 2018 05:36 |
Multiphase flow in a pipe with a CHT | wissal | CFX | 4 | June 12, 2017 12:15 |
Capillary pressure in multiphase flow in porous media | Lalit | FLUENT | 0 | March 21, 2013 01:24 |