|
[Sponsors] |
Finding output file set in Report File (Mornitors) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 27, 2019, 08:39 |
Finding output file set in Report File (Mornitors)
|
#1 |
New Member
ho-con
Join Date: Jan 2014
Posts: 14
Rep Power: 12 |
I set up the Report file at Monitors with the name LiftCoef.txt,
To running in Batch mode, I have a case file (named Input.cas) got from GUI setting. I want to ask where I can the output file (case and data file) after running batch mode and how I can set it up or write a commend in journal file to get the output. I mean where I can find or see the file LiftCoef.txt? |
|
June 28, 2019, 10:24 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,683
Rep Power: 66 |
when you did this set up, you also specified the location where it would be saved. If you didn't explicitly specify a path, then it goes into the working directory which is most likely the same directory as where the .cas file is located. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |
"parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |