Failed to export velocity in ensight-gold format

zizhou · July 22, 2019, 12:15

I did a simulation and showed the result velocity field, which looked fine. Then I exported the pressure and velocity, and change the ".encas" into ".case" so that it can be shown in Paraview. However, only the pressure can be shown, while the data about velocity, including the contour of velocity-magnitude and vector field of velocity, always lost. How can I fix this?

zizhou · July 22, 2019, 13:30

well I figured out the problem. The mesh I used only have one thin layer in 3D, which leads to no sample point in output file.

July 22, 2019, 12:15	Failed to export velocity in ensight-gold format	#1
zizhou New Member zizhou huang Join Date: Jul 2019 Posts: 18 Rep Power: 6	I did a simulation and showed the result velocity field, which looked fine. Then I exported the pressure and velocity, and change the ".encas" into ".case" so that it can be shown in Paraview. However, only the pressure can be shown, while the data about velocity, including the contour of velocity-magnitude and vector field of velocity, always lost. How can I fix this?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel	U.Golling	OpenFOAM Running, Solving & CFD	52	September 23, 2023 03:35
[ANSYS Meshing] ANSYS Academic can't export mesh to CGNS or STL format	ordinary	ANSYS Meshing & Geometry	0	December 19, 2018 13:52
A CFX-POST error (ver 14.5.7)	wangyflp88	CFX	2	July 22, 2017 00:17
Variables Definition in CFX Solver 5.6	R P	CFX	2	October 26, 2004 02:13
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11

July 22, 2019, 13:30		#2
zizhou New Member zizhou huang Join Date: Jul 2019 Posts: 18 Rep Power: 6	well I figured out the problem. The mesh I used only have one thin layer in 3D, which leads to no sample point in output file.