 |
 |
 |
|
|
|
[Sponsors] | ||||
July 27, 2019, 04:01
|
Import surface as surface (not interface)
|
#1 |
|
New Member
Jordi Iglesias Deutu
Join Date: Jul 2019
Posts: 1
Rep Power: 0  |
Hello
I have a complex geometry with many holes, to know the flow rate in each hole, I created some surfaces in Spaceclaim. When I open Fluent after meshing, these surfaces become automatically an interface, how can I import them as a surface just to monitor flow rate? Create the surfaces inside fluent is much more complicated. Thank you so much in advance! |
|
|
|
|
 |
| Tags |
| flow rate, fluent, import, interface, surface |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
| Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
| [snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Linear Mode
