Checking the given condition

sakthi_s · October 22, 2019, 06:00

It is difficult to check the condition set for cell zone & boundary condition by clicking edit for each and every zone (particularly when are many number of zones).
So is there any possibility to export the given cell and boundary condition of all zones to an excel file, so that it can be checked at once?

LuckyTran · October 22, 2019, 11:02

Code:

file/write-settings blah blah blah

will dump all settnigs and

Code:

file/write-bc balh blah blah

will dump all the bc settings into a text file

sakthi_s · October 23, 2019, 23:21

Quote:

Originally Posted by LuckyTran

Code:

file/write-settings blah blah blah

will dump all settnigs and

Code:

file/write-bc balh blah blah

will dump all the bc settings into a text file

But I don't need all the settings, I just need certain conditions like material, internal emmissivity, diffuse fraction etc.,

LuckyTran · October 24, 2019, 05:55

If you expect that much control...

It's better to learn some basic TUI commands to just set those settings on all the surfaces you desire, or learn some scripting. You don't need to "check the bc's" just apply them.

October 22, 2019, 06:00	Checking the given condition	#1
sakthi_s New Member Sakthi Join Date: Oct 2019 Location: Chennai Posts: 3 Rep Power: 6	It is difficult to check the condition set for cell zone & boundary condition by clicking edit for each and every zone (particularly when are many number of zones). So is there any possibility to export the given cell and boundary condition of all zones to an excel file, so that it can be checked at once?

October 22, 2019, 11:02		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,674 Rep Power: 65	Code: file/write-settings blah blah blah will dump all settnigs and Code: file/write-bc balh blah blah will dump all the bc settings into a text file

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what "If" condition means in rebound	brbbhatti	OpenFOAM Programming & Development	0	August 12, 2014 09:18
Internal flow operating condition?	kookguy	FLUENT	2	June 26, 2014 00:15
cgns grid problem	praveen	SU2	20	March 10, 2014 14:09
checking for C++ compiler default output file name... configure: error: C++ compiler	dhxlxz	SU2 Installation	2	September 7, 2013 11:08
[GAMBIT] Problem with interior faces	miro2000	ANSYS Meshing & Geometry	11	August 24, 2013 14:00

October 24, 2019, 05:55		#4
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,674 Rep Power: 65	If you expect that much control... It's better to learn some basic TUI commands to just set those settings on all the surfaces you desire, or learn some scripting. You don't need to "check the bc's" just apply them.