|
[Sponsors] |
May 8, 2020, 08:53 |
Y+ values
|
#1 |
New Member
Can
Join Date: Oct 2019
Posts: 4
Rep Power: 6 |
I am new to the Ansys Fluent. I want to a calculate 3d object drag coefficient but it doesn't consistent with real values so i susptect my mesh. I share my y+ values. Is it correct ?
p.s. I use spalart - allmaras models, compressible flow (ideal gas with viscosity model is sutherland), v0 = 2.8 mach, inlet boundary conditions far field pressure and outlet conditions pressure outlet. (Sorry my English.) |
|
May 8, 2020, 09:50 |
SA Model
|
#2 |
Senior Member
|
Though SA model is less sensitive to near wall mesh quality, still, you need to use a mesh much finer than that you have. should be of order 1, i.e., below 10 to give good accuracy.
__________________
Regards, Vinerm PM to be used if and only if you do not want something to be shared publicly. PM is considered to be of the least priority. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TimeVaryingMappedFixedValue | irishdave | OpenFOAM Running, Solving & CFD | 32 | June 16, 2021 06:55 |
using chemkin | JMDag2004 | OpenFOAM Pre-Processing | 2 | March 8, 2016 22:38 |
Velocity values are normal but pressure values are too big | rv82 | OpenFOAM Running, Solving & CFD | 4 | April 13, 2015 03:59 |
Setting patch field values equal to internal field values | leroyv | OpenFOAM Programming & Development | 1 | October 21, 2014 15:49 |
Plotting raw data values | Wilesco | Siemens | 0 | January 5, 2006 05:34 |