|
[Sponsors] |
November 29, 2020, 07:59 |
Interface with dynamic mesh
|
#1 |
New Member
Join Date: Oct 2018
Posts: 11
Rep Power: 7 |
Hi,
during the motion, between my two interface-surface a little gap appear and as its become wider (mainly on the top) its looks like that go out of tolerance and become a wall without volume-flow. Can i somehow change the limit of the tolerance or does anyone has an idea how to solve this problem? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" | GuiMagyar | OpenFOAM Meshing & Mesh Conversion | 3 | August 4, 2023 12:38 |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
Dynamic Mesh moving interface help | akash.iitb | FLUENT | 0 | August 23, 2010 23:53 |