Watertight workflow and geometry description

captainpimienta · December 23, 2020, 08:34

Is there a way too apply the describe geometry without watertight. My surface mesh will be faulty if following the tree, but want to keep the description step for internal walls.

captainpimienta · December 29, 2020, 15:57

hello,
I finally was able to solve my issue, if any of you are struggling with the same send me a message.

harshavardhanps383 · March 8, 2021, 11:34

hello captain,
How you solved your problem?. Please explain it will help me.

captainpimienta · March 8, 2021, 11:56

Hello,

I made sure my internal volume geometry was not touching my main one, that way it gets identified as an internal region and allows internal bundary conditions

harshavardhanps383 · March 8, 2021, 22:26

Thank you for your reply.

December 23, 2020, 08:34	Watertight workflow and geometry description	#1
captainpimienta New Member Manuel Join Date: Dec 2020 Posts: 10 Rep Power: 7	Is there a way too apply the describe geometry without watertight. My surface mesh will be faulty if following the tree, but want to keep the description step for internal walls.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Need help optimizing my Fluent Meshing Workflow	DL598	ANSYS Meshing & Geometry	0	April 21, 2020 13:57
Using a Parameter Set with Fluent Meshing Workflow	ro_bb	FLUENT	1	July 18, 2019 06:06
Automatic workflow for geometry swapping - advice needed	jabeken	STAR-CCM+	2	February 18, 2019 07:05
What is Your Workflow for CFD Involving Deformed Geometry?	qwe11rty22	Structural Mechanics	2	March 24, 2017 01:39
Simulation of Flow through Complex 3D Geometry	EmersonKB	CFX	5	July 2, 2009 09:17

December 29, 2020, 15:57		#2
captainpimienta New Member Manuel Join Date: Dec 2020 Posts: 10 Rep Power: 7	hello, I finally was able to solve my issue, if any of you are struggling with the same send me a message.

March 8, 2021, 11:34		#3
harshavardhanps383 New Member Iharshavardhan reddy Join Date: Dec 2020 Posts: 18 Rep Power: 7	hello captain, How you solved your problem?. Please explain it will help me.

March 8, 2021, 11:56		#4
captainpimienta New Member Manuel Join Date: Dec 2020 Posts: 10 Rep Power: 7	Hello, I made sure my internal volume geometry was not touching my main one, that way it gets identified as an internal region and allows internal bundary conditions

March 8, 2021, 22:26		#5
harshavardhanps383 New Member Iharshavardhan reddy Join Date: Dec 2020 Posts: 18 Rep Power: 7	Thank you for your reply.