 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2021, 12:38
|
Taylor Couette flow symmetry case
|
#1 |
|
New Member
Join Date: Feb 2021
Posts: 1
Rep Power: 0  |
Hello,
I am working on Taylor Couette flow between concentric cylinders and the results are correct for the full case. however, I wanted to do symmetry case to improve the mesh. I have used periodic boundary condition +match control for the air and I got good results. However, when I try to add the cylinders in the case, I get wrong results. I don't know what am I doing wrong. I am using Ansys 19 R2. Fluent Thank you in advance |
|
|
|
|
 |
| Tags |
| concentric cylinders, periodic boundary, symmetry, taylor couette flow |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation of a chimney with heat in open atmosphere | Jurado | OpenFOAM Running, Solving & CFD | 9 | December 18, 2020 07:35 |
| [DesignModeler] DesignModeler Scripting: How to get Full Command Access | ANT | ANSYS Meshing & Geometry | 53 | February 16, 2020 15:13 |
| About Some Concepts:Laminar flow, turbulent flow, steady flow and time-dependent flow | Jing | Main CFD Forum | 8 | October 5, 2018 17:02 |
| Review: Reversed flow | CRT | FLUENT | 1 | May 7, 2018 05:36 |
| Channel flow with symmetry Plane not symmetric | Hillie | OpenFOAM Running, Solving & CFD | 0 | May 19, 2017 22:32 |
Linear Mode
