 |
 |
 |
|
|
|
[Sponsors] | ||||
Initialize transient run automatically with steady state results (Fluent, Workbench) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 6, 2021, 13:48
|
Initialize transient run automatically with steady state results (Fluent, Workbench)
|
#1 |
|
New Member
Join Date: Dec 2020
Posts: 19
Rep Power: 5  |
Hello,
I have Fluent cells in Workbench such that I would like to use the solution from the steady state run to initialize the transient run. It is configured so that the mesh is fed into both setup cells of steady/transient runs. Based on what I've read, I also connected the solution cell of the steady run with the solution cell of the transient run. However, after I finish running the steady case and try to solve the transient one, it still prompts me to initialize. Can anyone tell me what I'm doing wrong? Thanks! |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient simulation gives worse results than steady state simulation | jgross | CFX | 12 | January 21, 2021 12:21 |
| [Transient rotating domain initialization from steady state run | asanchez84 | CFX | 0 | June 13, 2019 17:28 |
| Convergence in Transient; Divergence in Steady State | artkingjw | FLUENT | 6 | May 24, 2018 02:51 |
| Steady state solution ----> transient | nskelly | OpenFOAM Running, Solving & CFD | 4 | March 12, 2018 11:49 |
| Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 13:41 |
Linear Mode
