 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2021, 08:31
|
Define point for a specific value
|
#1 |
|
New Member
Luke Anonymous
Join Date: Feb 2021
Posts: 8
Rep Power: 5  |
Hello, I am doing a simple transient heat transfer problem and want to plot the location of the edge of the boundary layer over time. So, I want to be able to define my point as being located on a line, with the variable temperature, but instead of MaxVal or MinVal, I want it to be 27 C. Is this possible? If so how
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
| [snappyHexMesh] How to define to right point for locationInMesh | Mirage12 | OpenFOAM Meshing & Mesh Conversion | 7 | March 13, 2016 14:07 |
| use of pointers in specific heat udf | mdakbari | Fluent UDF and Scheme Programming | 0 | April 18, 2014 11:37 |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
| Free surface boudary conditions with SOLA-VOF | Fan | Main CFD Forum | 10 | September 9, 2006 12:24 |
Linear Mode
