|
[Sponsors] |
September 8, 2021, 11:29 |
Topology Error in Fluent
|
#1 |
New Member
Join Date: Sep 2021
Posts: 1
Rep Power: 0 |
I applied match control in mesh editor , but I am getting a topology error , I tried to change the coordinate also but it is not working , also the area of faces are also same.
Can someone please with this topology error? I am doing periodic analysis for cylinder domain. Screenshot (49).jpg |
|
Tags |
ansys, cfd, cfd analysis, error, mesh |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to run fluent from matlab without using aas toolbox? | artemis96 | ANSYS | 7 | May 23, 2022 13:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 04:22 |
heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 07:22 |
Fluent crash on writing data file after thousand iterations | Chuck87 | FLUENT | 0 | September 2, 2015 17:17 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 17:48 |