|
[Sponsors] |
UDF gradient od temperature and turbulent viscosity at wall |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 21, 2021, 13:02 |
UDF gradient od temperature and turbulent viscosity at wall
|
#1 |
New Member
Wojciech Gołda
Join Date: Nov 2020
Posts: 16
Rep Power: 5 |
Hello,
I need to write an UDF to get gradient of temperature on the wall. Next I need to calculate turbulent viscosity on that wall and at the end use equation to calculate turbulent heat flux. Could anyone help me with that? Where to start, how to do it, can I do it in one UDF? Greetings, WG |
|
November 21, 2021, 22:52 |
|
#2 |
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
you may start with Ansys fluent customization manual
look for Reconstruction Gradient
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 00:04 |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Too low temperature at combustor outlet | romekr | FLUENT | 2 | February 6, 2012 10:02 |