|
[Sponsors] |
January 5, 2022, 17:30 |
Deforming Mesh Zone - 2.5D Remeshing
|
#1 |
New Member
İstanbul
Join Date: Nov 2021
Posts: 4
Rep Power: 4 |
I used a single body.
While dynamic meshing, the rotating part collides with the inlet hole. How should I define it? Remeshing does not occur in wedge(prism) mesh even though I selected 2.5D. When I choose tetrahadral mesh, I can do remeshing. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ANSYS Meshing] How to mesh this geometry to get best quality?(provide your suggestion) | Roh | ANSYS Meshing & Geometry | 1 | October 10, 2017 13:23 |
Separate mesh in one zone by another zone | lazybone | FLUENT | 0 | June 12, 2017 08:56 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |