Iso-Surface mesh for specific geometry

Dangotes · February 1, 2022, 09:45

hello,

in the file attached there's the geometry I'm working with, its a part of a 3D shell and tube with phase changing material (marked in green) what's shown in the picture is the geometry in YX plane and its length is across the Z axis. what I'm trying to figure out is how i can see a contour of the melting/solidification on the black line marked (or something like it) where it goes through all the length of the geometry. is it possible to do this with Iso-Surface? the axis is defined to be the center of the arc of the tube.

AlexanderZ · February 2, 2022, 20:26

I don't know the way other than dividing your domain with 3D surface in advance
so later you may select it in the list of available surfaces to plot contour

February 2, 2022, 20:26		#2
AlexanderZ Senior Member Alexander Join Date: Apr 2013 Posts: 2,363 Rep Power: 34	I don't know the way other than dividing your domain with 3D surface in advance so later you may select it in the list of available surfaces to plot contour __________________ best regards ****************************** press LIKE if this message was helpful

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[snappyHexMesh] snappyHexMesh generates not planar surface	krzychu111	OpenFOAM Meshing & Mesh Conversion	2	April 23, 2020 16:38
[ICEM] Holes in geometry appearing when surface mesh size decreases	CCHunter	ANSYS Meshing & Geometry	0	February 20, 2015 21:30
Cluster ID's not contiguous in compute-nodes domain. ???	Shogan	FLUENT	1	May 28, 2014 15:03
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?	jash	ANSYS Meshing & Geometry	19	July 23, 2013 18:48