|
[Sponsors] |
February 24, 2022, 20:37 |
How can I get data from Iso clips?
|
#1 |
New Member
NJ
Join Date: Sep 2020
Posts: 2
Rep Power: 0 |
Hi, I have some questions about the iso clips.
As the picture shows, the iso clip surface is a part of the sidewall and bottom wall. In my design, I can get average heat flux on the sidewall and bottom wall by using 'areaAve(Heat Flux)@surface'. But it always shows 'undefined' when I want to get average heat flux on the iso clip surface in the same way 'areaAve(Heat Flux)@Iso Clip'. Any difference for the ios clips surface? |
|
September 19, 2023, 05:50 |
|
#2 |
New Member
SUBHAM
Join Date: Sep 2021
Posts: 4
Rep Power: 4 |
Have you found a solution to this problem? I am also facing the exactly same issue
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
[OpenFOAM] Paraview doesn't seem to be picking up data generated by icofoam | MikeHersee | ParaView | 2 | January 6, 2015 08:27 |
Data Produced From Fine Marine Cant Match with The Experimental Data | PeiSan | Fidelity CFD | 4 | August 23, 2014 05:33 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |