[albus04*-*]

Hi, I have some error with CFD post processing.
I used workbench.
After using ansys fluent, I made result file, and I started ansys post processing.
But it didn't open, and there are lot of errors.

'Application error(s) occurred in CFD-Post. To view the full message please click 'Show Details' or review in the Message Windows.

So, I checked 'Show Details', and I found this sentence.
CFD-Post Application Error


ERROR
Error reading file 'C:\Personal Files\graduation_ research\for research\1cm_6cm_radius_10cm_files\dp0\FFF\Fluent\ 1cm_6cm_rad 10cm.flprj':
The run 'RunSteady' in simulation 'Simulation' contains transient output but no output files were defined.


What should I do for solving this problem?
Can anybody help?

[Indra]

Originally Posted by albus04*-*

Hi, I have some error with CFD post processing.
I used workbench.
After using ansys fluent, I made result file, and I started ansys post processing.
But it didn't open, and there are lot of errors.

'Application error(s) occurred in CFD-Post. To view the full message please click 'Show Details' or review in the Message Windows.

So, I checked 'Show Details', and I found this sentence.
CFD-Post Application Error


ERROR
Error reading file 'C:\Personal Files\graduation_ research\for research\1cm_6cm_radius_10cm_files\dp0\FFF\Fluent\ 1cm_6cm_rad 10cm.flprj':
The run 'RunSteady' in simulation 'Simulation' contains transient output but no output files were defined.


What should I do for solving this problem?
Can anybody help?

Looks like it can't find the files it is looking for. If you used workbench, you wouldn't have had the need to write results file in the first place. That is done automatically if cfd post is attached to your fluent session.

I'm not sure what post processing you are doing but Fluent in-built post processing does pretty much everything, why not try that instead of changing applicaiton.