[aniket7017]

I am running a two way FSI coronary artery bifurcation simulation with artery being a hyperelastic material. I wanted to use quasi-newtonian stabalisation method so i extracted the system coupling and case file for both fluent and transient and did the necessary steps required to run the simulation through external system coupling gui(not inside workbench).i got results in EnSight format.Is there a way that i view result in CFD post and in mechanical post processor like i would have i,f i would have ran the system coupling in workbench itself.

Thank you

[amscosta]

Hi,
I am working in something similar. Maybe we can exchange some knowledge.
As far as I know you must perform everything inside the workbench gui, see the 2way hyperelastic flap tutorial as reference.

[Indra]

Originally Posted by aniket7017

I am running a two way FSI coronary artery bifurcation simulation with artery being a hyperelastic material. I wanted to use quasi-newtonian stabalisation method so i extracted the system coupling and case file for both fluent and transient and did the necessary steps required to run the simulation through external system coupling gui(not inside workbench).i got results in EnSight format.Is there a way that i view result in CFD post and in mechanical post processor like i would have i,f i would have ran the system coupling in workbench itself.

Thank you

If you ran it in workbench, the result should have been shared in cfd post automatically. Your fluent analysis system will have a result section below setup and solution, you can open that to access your results, no extra operation needed. Same can be done for mechanical.