 |
 |
 |
|
|
|
[Sponsors] | ||||
March 31, 2022, 09:42
|
S2S radiation model
|
#1 |
|
New Member
Guan-Xun Chen
Join Date: Mar 2022
Posts: 1
Rep Power: 0  |
Hello. I have a problem here.
I'm working on a natural convection problem using ANSYS fluent. When considering radiation model, I found that there are two S2S model can be selected (As shown in the figure 1). My question is: 1) Which should I choose and what's the difference between these two models? 2) In other of my cases, sometimes there would be two S2S model but sometimes only one abvailable. How does this happen? Thx a lot for any response! Figure 1: https://ibb.co/31qzG47 |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent Radiation/porous media | Schmitt pierre-Louis | FLUENT | 26 | September 1, 2016 10:29 |
| Boundary conditions for S2S radiation model in naturally convected square cavity | Mahendra_Paipuri | FLUENT | 1 | October 17, 2014 05:46 |
| Radiation Modeling | Chris89 | CFX | 20 | August 14, 2014 07:51 |
| View Factor on S2S radiation model | Kristofer. | FLUENT | 1 | May 31, 2013 08:10 |
| how to write and read view factor file in radiation model S2S | chhanwal | FLUENT | 1 | March 25, 2009 10:54 |
Linear Mode
