 |
 |
 |
|
|
|
[Sponsors] | ||||
Periodic Boundary Condition Error in ANSYS Fluent 2022 R1 |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 1, 2023, 17:19
|
Periodic Boundary Condition Error in ANSYS Fluent 2022 R1
|
#1 |
|
Senior Member
Sakun
Join Date: Nov 2019
Location: United Kingdom
Posts: 169
Rep Power: 8  |
Hi,
I was able to apply periodic boundary condition and ran my single blade compressor simulation in Fluent 2021 R2 and when i changed in to 2022 R1 version (University updated the version) , i am getting following error, Error: wta(1st) to symbol->string Error; Object: #f (Attached picture) Please advise on this  Thank you for your time. |
|
|
|
|
|
February 4, 2023, 12:03
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 35 |
your settings are incorrect
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
|
|
|
February 4, 2023, 13:35
|
|
#3 | |
|
Senior Member
Sakun
Join Date: Nov 2019
Location: United Kingdom
Posts: 169
Rep Power: 8 |
Quote:
Hi , Thank you very much for the reply  I re-applied all the steps i did in 2021 R1 to 2022 R1 without missing any value or setting. Even the 2020 version works fine with my all the settings for my case. |
||
|
|
|
||
|
| Tags |
| ansys 2022 r1, compressor blade, fluent, periodic conditions |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 17, 2020 00:44 |
| CFD analaysis of Pelton turbine | amodpanthee | CFX | 31 | April 19, 2018 19:02 |
| periodic boundary condition (translational) fluent 6.3 | haihek | FLUENT | 3 | January 22, 2014 05:10 |
| Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
Linear Mode
