|
[Sponsors] |
Problems with reading Prodile Boundary Conditions |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 8, 2023, 13:10 |
Problems with reading Prodile Boundary Conditions
|
#1 |
New Member
Leon Roemer
Join Date: May 2023
Posts: 1
Rep Power: 0 |
Hello,
Im currently doing an CFD-combustion-simulation of waste in ANSYS FLUENT. The comubustion chamber is seperated in two parts. The data at the outlet of the first part of the combustion chamber should be the Inlet-Boundaray-Condition for the second part. Therefore I want to use profiles. I write a profile with the data from the first simulation (i write it the way it is described in the Manual of Ansys FLuent). While Reading my written profile doesn't work, because the number of data points in the field (1) is not equal to the number in the profile (2100). Now I don't know hot to fix this problem. Can anybody help me with that? Thank you very much!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |