CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

How to converge natural convection with bad mesh.

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   November 9, 2023, 22:47
Question How to converge natural convection with bad mesh.
  #1
New Member
 
Xander
Join Date: Oct 2023
Posts: 3
Rep Power: 3
thermokopf is on a distinguished road
I'm simulating with Fluent (Icepak) with a very skewed mesh, and we cannot simplify geometry at this point.

Transient natural convection with Ra ~ 1e8. Been using laminar solver in an older version of Icepak/Fluent, which detects divergence but corrects itself.

In old Fluent/Icepak, warning is:

# Divergence detected in AMG for pressure correction: protective actions enabled!
# Divergence detected in AMG for pressure correction, temporarily solve with BCGSTAB!


This happens frequently during iterations, but simulation still converges/completes.

With new Fluent/Icepak, however, we get this:

Stabilizing pressure correction to enhance linear solver robustness.
Stabilizing pressure correction using GMRES to enhance linear solver robustness.
Divergence detected in AMG for pressure correction
Error at host: floating point exception


It seems like new Fluent/Icepak does not have the same protective mechanisms as old Icepak.

1. How to stabilize natural convection with a bad mesh?

2. How to use whatever old Fluent/Icepak was using to achieve a complete solution?
thermokopf is offline   Reply With Quote

Reply

Tags
divergence, fluent - parallel, icepak, natural convection, pressure

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
flow over cylinder in openFoam saeed jamshidi OpenFOAM Pre-Processing 3 August 11, 2023 16:16
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" GuiMagyar OpenFOAM Meshing & Mesh Conversion 3 August 4, 2023 13:38
foam-extend-4.1 release hjasak OpenFOAM Announcements from Other Sources 19 July 16, 2021 06:02
[snappyHexMesh] very bad quality snapped mesh federicabi OpenFOAM Meshing & Mesh Conversion 18 September 26, 2018 11:33
[mesh manipulation] Importing Multiple Meshes thomasnwalshiii OpenFOAM Meshing & Mesh Conversion 18 December 19, 2015 19:57


All times are GMT -4. The time now is 00:16.