 |
 |
 |
|
|
|
[Sponsors] | ||||
March 19, 2024, 10:26
|
Setting up Periodic Boundaries
|
#1 |
|
New Member
D-Bew
Join Date: Mar 2024
Posts: 1
Rep Power: 0  |
Background - I am using Ansys Fluent to run simulation on a wind turbine blade. The model was made in SolidWorks and imported across as a step file. Spaceclaim was used to make the flow domain area. The playlist below outlines the steps taken. https://www.youtube.com/playlist?lis...euAWEaqdhtTr8n
When trying to set the periodic boundaries the following error appears. Error: Periodicity could not be automatically calculated. The selections that you provided are non-planar. Use Manual option Error Object: #f I know I can do this manually, but it would be good to know what is causing this error and how it could be avoided/fixed. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issue applying periodic interface to boundaries | ValorToMe | STAR-CCM+ | 0 | October 16, 2020 08:57 |
| Periodic Interface: Symmetry Boundaries are not matching | mazhar16823 | Main CFD Forum | 2 | August 29, 2020 18:30 |
| [Commercial meshers] Periodic (cyclic) boundaries. ICEM Mesh to OpenFOAM | 123 | OpenFOAM Meshing & Mesh Conversion | 0 | May 6, 2014 06:49 |
| Why can't I make the boundaries periodic? | Alina | FLUENT | 5 | April 12, 2012 15:06 |
| periodic boundaries - flow through a net | PK | FLUENT | 0 | July 12, 2007 12:58 |
Linear Mode
