|
[Sponsors] |
July 22, 2000, 04:21 |
how to import ASCII data to Gambit?
|
#1 |
Guest
Posts: n/a
|
Hi All, I am looking at the turbulent flow over different 2-D profiles. Often, it would be (much) easier to make a simple ASCII file with coordinates of a profile (edge) and then import these data to Gambit than to draw this surface in Gambit. I tried to File->Import->ASIC - didn't work. Does somebody know how to do it? Thanks
|
|
July 22, 2000, 05:42 |
Re: how to import ASCII data to Gambit?
|
#2 |
Guest
Posts: n/a
|
Try to check the versions of the acis format file, with gambit1.1 from autocad2000 it works correctly.
|
|
July 24, 2000, 09:15 |
Re: how to import ASCII data to Gambit?
|
#3 |
Guest
Posts: n/a
|
Hi, an ASCII format is not an ACIS format!! The best way for reading an ASCII format with coordinates is to use the journal file. Your journal file must content the right syntax for the command "create vertex", eg. "vertex create coordinates 1 1 1", where 1 1 1 are the value of x,y,z coordinates. Best Regards Pavel
|
|
July 24, 2000, 20:21 |
Re: how to import ASCII data to Gambit?
|
#4 |
Guest
Posts: n/a
|
thank you
|
|
July 26, 2000, 17:21 |
Re: how to import ASCII data to Gambit?
|
#5 |
Guest
Posts: n/a
|
Gambit allows import of point data from an ascii file with xyz coordinates. It can automatically create vertices, curves and surfaces. These options are available through File -> Import -> ICEM Input & File -> Import -> Vertex Data. Please contact your Fluent Support Engineer for details.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Importing Gambit data into Fluent | Tyred | ANSYS Meshing & Geometry | 1 | April 18, 2009 13:53 |
Export data from GAMBIT to GAMBIT | Sanjay Jain | FLUENT | 1 | April 3, 2008 00:44 |
Import to CAD - Gambit | guest | Main CFD Forum | 5 | November 21, 2002 10:37 |
I-DEAS CAD data import with boundary conditions | Yunus | Siemens | 1 | June 1, 2001 10:04 |
Autocad import into Gambit | Paul | Main CFD Forum | 5 | July 12, 1999 04:19 |