|
[Sponsors] |
April 27, 2001, 05:52 |
gambit export
|
#1 |
Guest
Posts: n/a
|
Hi
I have problems to export a mesh (from Gambit) with periodic boundaries. I read an error message :mesh not created because of periodic boundaries faces problem If I change the periodic boundaries in a symmetric bound, I have no problem to export this mesh. Nota : periodic faces are linked It would be very nice if someone could help me bye olivier |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
export 2d model from solidworks to gambit | bad080boy | Main CFD Forum | 2 | April 29, 2011 14:31 |
mesh missing after export in gambit | morteza08 | ANSYS Meshing & Geometry | 1 | July 26, 2010 01:10 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Export data from GAMBIT to GAMBIT | Sanjay Jain | FLUENT | 1 | April 3, 2008 00:44 |
export or convert gambit mesh to CGNS | zaidun | FLUENT | 6 | April 20, 2006 04:48 |