|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hi everyone..
trying to figure out on how to use parallel processing in fluent. i tried typing in the parallel version of fluent and specifying the nodes that i want for the problem but after pressing enter..it sort of crash on me. can someone help me to figure this thing out? maybe a simple procedure to run fluent in parallel? thanks.. nurul |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi Nurul 1) what version of fluent u r using? 2) How big ur mesh ?
I think I can help. DC |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Hi I would also like to know how to use parallel processing. How do you do this?
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parallel processing of OpenFOAM cases on multicore processor??? | g.akbari | OpenFOAM Running, Solving & CFD | 31 | November 1, 2017 10:25 |
multiphase solver - parallel processing - GAMG | thibault_pringuey | OpenFOAM Programming & Development | 2 | August 27, 2013 23:03 |
HP MPI warning...Distributed parallel processing | Peter | CFX | 10 | May 14, 2011 07:17 |
bubbly flow and parallel processing | mvee | FLUENT | 0 | September 12, 2007 06:08 |
About parallel processing in Linux | tuks | CFX | 10 | August 8, 2005 09:22 |