|
[Sponsors] |
February 15, 2002, 12:57 |
help on gambit
|
#1 |
Guest
Posts: n/a
|
Hi, all
I am trying to generate a 3-D duct (some kind of like an elbow) in Gambit, but I have no Autocad at hand, so I plan to use vertex data, since I have some gemetry data on the duct surface. The problem is that I have no manual for the gambit v1.3.0, can anybody give me a help on the format of vertex data files. Thanks Hua |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Does Gambit has a maximum allowable grid number? | spartan1516 | ANSYS Meshing & Geometry | 7 | March 25, 2010 09:08 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
Problem starting Gambit | ViHAR MALViYA | FLUENT | 0 | November 10, 2006 10:26 |