|
[Sponsors] |
June 11, 2002, 03:46 |
DPM, warning...
|
#1 |
Guest
Posts: n/a
|
Hi I'm A new fluent user, I'm modelising a water spray evaporation&momentum via DPM model. Using plan symetry (XOZ) of the geometry (cubical) and a Plain orifice atomizer model I recieve the message below: "Warning, injection # not found in domain (x,y;z)# Knowing that one coordinate of the injector is exactly on the symetrye plan (just on the edge ) and that I set a 40 particle stream number. Does any one has any idea about this warning best regards for all
|
|
June 12, 2002, 02:11 |
Re: DPM, warning...
|
#2 |
Guest
Posts: n/a
|
Try to move your injection point a little from say (x,y)=(20,30) to (x,y)=(20.001,30.001). This should ensure that your injection point really is in the domain, and it will not alter your solution.
Cheers Christian |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
latest OpenFOAM-1.6.x from git failed to compile | phsieh2005 | OpenFOAM Bugs | 25 | February 9, 2010 04:37 |
Compilation errors in ThirdPartymallochoard | feng_w | OpenFOAM Installation | 1 | January 25, 2009 06:59 |
Can anybody help me to solve the list errors while compiling Openfoam 15 on Opensuse 103 32bit | coompressor | OpenFOAM Installation | 0 | November 12, 2008 19:53 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |