|
[Sponsors] |
June 24, 2002, 15:30 |
creating volume by stitching faces
|
#1 |
Guest
Posts: n/a
|
When I tried to creat a volume by stitching faces, I end up with following Message and Error,
Message:All the faces are selected twice Error:Is this a open shell? Any help appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
alphaEqn.H in twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM Bugs | 15 | May 1, 2016 16:12 |
virtual faces, volumes creating problems | ambermgupta | ANSYS Meshing & Geometry | 3 | July 2, 2010 09:57 |
blockMesh: block with 6 vertexes | dani | OpenFOAM | 3 | June 25, 2009 13:13 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
negative volume & collapsed faces | Tipakorn | Siemens | 1 | March 7, 2006 00:41 |