|
[Sponsors] |
December 14, 2002, 08:48 |
MRF help please
|
#1 |
Guest
Posts: n/a
|
Dear friends, I am handling rotating flow. For that I am using MRF. I have one outer, one inner cylinder rotating with a differential speed of 58rpm. In between one helix is also present. When I did not used the MRF, the angular velocity distribution is quite different than the angular velocity when I used the MRF. Can any one tell, why sudden change in angular velocity distribution??? Please i am waiting for ur reply. Thanks
|
|
December 19, 2002, 01:20 |
Re: MRF help please
|
#2 |
Guest
Posts: n/a
|
Waht did you use beside MFR, is it sliding mesh? Is the difference very big?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rotating wall inside of an MRF zone - fixedValue or movingWallvelocity? | evrikon | OpenFOAM Running, Solving & CFD | 3 | April 30, 2015 03:51 |
mrf doesn't work | armand | Siemens | 1 | April 1, 2011 18:46 |
Should an empty MRF zone really induce this much cross-flow? | sylvester | OpenFOAM | 5 | November 18, 2010 03:48 |
Implicit VOF + MRF | Grzegorz | FLUENT | 3 | February 27, 2009 07:11 |
Moving Mesh and MRF | Romain | FLUENT | 1 | May 16, 2002 03:45 |