Home > Forums > Software User Forums > ANSYS > FLUENT

Gambit problem

Mark Forums Read

Reply

Search this Thread

January 10, 2003, 06:38	Gambit problem	#1
Bo Jensen Guest Posts: n/a	Hallo everyone Has anyone seen this error messages before when tryin to start Gambit? Cannot open connect stream. TRANS(SocketINETGetAddr): tnamebysocket() failed TRANS(SocketINETConnect): TRANS(SocketINETGetAddr) () failed TRANS(open): transport open failed for tcp/LOCALPC:0 Unable to open display Regards Bo

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit geometry problem	cestrin	FLUENT	3	July 4, 2012 03:33
[Commercial meshers] Problem with Mesh conversion Gambit msh Foam	Rachid BANNARI (Bannari)	OpenFOAM Meshing & Mesh Conversion	25	September 11, 2011 08:58
Gambit installation problem	Panos	FLUENT	4	March 5, 2009 23:44
Problem meshing with Gambit	Adrian	FLUENT	8	October 7, 2008 09:39
Startup Problem in Gambit 2.2 with WindowXP	Win Win Maw	FLUENT	3	January 25, 2006 12:09

All times are GMT -4. The time now is 01:44.