|
[Sponsors] |
August 5, 2003, 14:52 |
udf to output velocity at some point
|
#1 |
Guest
Posts: n/a
|
I'd like to write out the velocity vs time at several points. I defined some point surfaces, but seems I can't access these points by UDF. Anybody know if I am right or not? If I am right, so how can I output these stuffs? Any advice would be appreciated.
Jun |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for Inlet velocity | Mijin Kim | FLUENT | 0 | September 28, 2009 04:50 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |
How to output unsteady velocity profiles? | Jason | FLUENT | 3 | August 8, 2007 09:40 |
Urgent! Help on UDF to set inlet velocity | Ray Hong | FLUENT | 4 | December 30, 2005 12:32 |
UDF problem : inlet velocity in cyl. coord. system | Jongdae Kim | FLUENT | 0 | June 15, 2004 11:21 |